3D Project Process Part 3

I bought a gold wire for the sink and i cut 2.5cm using scissors 

i measured it with the ruler to get the right dimision.

 

then i bend the upper part to be the place where the water come out from. and i tried to make a neat bend because i don't pliers but i did good.

then i cut another 3cm gold wire to hang these templates on it so i started by cutting them from the paper using craft knife.   

I used PVA glue for this part 

this is the outcome after i glue them to the wire and the i will stick them in the wall of my kitchen.

i got some felts and fabrics to make the furniture from 

I start with cutting small part of the dark blue felt and joining the two corners together 

I used this glue for this process because it give clear end for the felt and fabrics.

then i closed the lower part to start adding the filling to the felt to make the pillow.

this after i added the filling in to the piece.

then i closed the upper part with the glue.

I repeated this processes to do all my small pillows 

i start cutting the base, sides etc of the furniture to start making it.

for this part i used white felt for the filling to be easier for me to control it because i have to be careful with this part as well as it will make it fluffy as well.

i cut the same size of the white felt as the size of the mount board.

I then glue it to the base that i cut using the clear glue.

i then cut the dark blue felt little bigger than the mount board to close all the part.

to close the sides i cut small piece of the corners and i glue them in then i glue the rest over then to have good outcome.

and this is the outcome for this piece.

this is the continuing of making a sofa.

I start with doing the armrest so i did it a little smaller than backrest and bit wider than the seat cushions so i did it 3cm by 2cm 

I cut them off from the mount board 

i then did the same process from the last post, i cut white felt the same size of the armrest

And i glue the white felt using clear glue.

here i cut the dark blue felt a bit larger than the mount board to be able to close all the parts together 

and this the outcome for the armrest. i did the process for the second piece of armrest 

here i started with the seat cushions i cut the template from the mount board i 3x 

and i did the same process that i used for the armrest to this  

this is a process shot of the cushions while I am doing them

here i cut the last one 

and then i started to stick them together using clear glue. 

this is the outcome of the sofas.

here i start to draw the table on the mount board.

I then cut them off using craft knife