Cohoom Technical practice-1

In this post, I will show the process of doing the floor plan in the application Cohoom 

Firstly, I opened Cohoom, then new project. As you can see above I clicked on 'Draw' to start drawing my floor plan. 

After that, I started drawing the floor plan, but before I needed to change the unit form "ft to m". 

So from the top right corner I clicked on my profile then I clicked on the first option "Preferences". 

this page opened, On "general" I clicked on Unit then change it to Meters. 

Now I started drawing my floor plan. to do this I clicked on floor plan from the top left bar then I chose Wall (B) as the image above shows 

To have more accurate dimensions, when i start drawing the wall while I am drawing I clicked on the backspace in my keyboard then i typed the wall width which is 15. I did the same process for the other wall the length is 20 m sq. 

I then to make a curve wall for the showcase area I clicked on the wall and a small bar on the right appeared I clicked on the first option which is the curve option. 

in the right there is a bar shows the information and dimensions of the design. from their I change the name of the room to have a better understanding for each area. 

Lastly, I changed the height of the wall to 4 meter as you can see in the image above.

This is the floor plan of my store. 

Then I started to do the fitting room layout so firstly I did a small curve to the opening wall. 

Then i typed arc door from the left bar and i chose one of them and dropped it into the curve wall that i did. I then changed the measurements of the arc door so the length of it can be the same which is 0.30 m