Cohoom Technical practice-2

To change the floor material I clicked on the wall first as you can see the image below then I clicked on floor editor to change the floor material. 

After I clicked on the floor editor this page opened for me In the left corner I can see the 3D view so no need to go back and see the 3D view. After that in the left bar there to many option but I typed in the search section "Marble" so it can be easier for me to find what I want. After I find it I pressed on the floor that i found Then i dropped it to the floor that is in the middle as you can see in the image below.

After I chose the floor material I clicked on the X button in the top right corner. 

Then I started to put the the glass in the front for the display area by typing window in the left bar.

I then changed the height of the windows to make them from the floor to the celling from the right settings i changed the height to 4. 

Then i added electronic doors in the both sides, I then clicked on Material editor to chabge the colour of the door.

Anyway there was nothing to change so i kept it the same and clicked on done in the top right corner.

I changed the length to 2.3 m and the height to 3 m. 

Know to add a built in lights I clicked to the wall that i need then on wall editor 

after that i clicked on add guidelines to have more accurate measurements

After i chose the guidelines i cliked on the bottom line then I dragged it up as you can see in the image above. 

i the clicked on Line and draw over the guideline that i did 

Here I did another line above the line that i did before and then i changed the extensions which decide the depth of the hole. I changed the extension of the first and last line to 0.1 and the line in the middle to 0.05. 

Then i just clicked on the middle line  which seen as a blue line in the image above, and the left bar settings opened for me 

i then clicked on internal light strip 

and here i made the 3d view big so i can know what i am doing. firstly i clicked on the selection edit from the left settings. Furthermore, i changed the light colour from the left bar and i kept the brightness 200% 

when i selected on the "selection edit" I started to move the light stipe inside the hole that did. so whenever you move the arrow the light with move as well either down, left, up, right, it depends where i move the arrow. 

 I did a quick render to see how it looks.